ITC - What's news?

Replies to This Discussion

Permalink Reply by Deelip Menezes on September 10, 2009 at 8:46am

I hear that is is pretty close to release. I see no reason why SDS support should not be there. Bricscad has it. Not sure if it will be binary compatible or will require a recompile.

▶ Reply to This

Permalink Reply by C++ on September 10, 2009 at 10:18am

Is this going to be the new 6.7 version? Should run all the SDS modules just fine ; )

▶ Reply to This

Permalink Reply by Deelip Menezes on September 10, 2009 at 10:21am

No. I hear that this will be the 7.0 version based on the DWGdirect platform. But we have been hearing that for years now. :-(


C++ said:

Is this going to be the new 6.7 version? Should run all the SDS modules just fine ; )

▶ Reply to This

Permalink Reply by Yogi on September 10, 2009 at 4:06pm

ITC has released its IntellliCAD 7.0 to its members...

▶ Reply to This

Permalink Reply by Randy Mahoney on January 30, 2010 at 6:14am

Anybody heard anything about when Icad 7 versions from ITC members (like Cadopia and others) might be available?
Just checking.

▶ Reply to This

Permalink Reply by C++ on January 30, 2010 at 2:14pm

Aren't CADopia and the ITC tied up it some legal battle? All is quiet on the IC7 front.. 2011 maybe?

▶ Reply to This

Permalink Reply by Deelip Menezes on January 30, 2010 at 2:41pm

Not sure where the ITC and Cadopia are headed.

Regarding IntelliCAD 7, I have stopped bothering. It will come out when it has to.

▶ Reply to This

Permalink Reply by Randy Mahoney on January 31, 2010 at 1:20am

Thanks for the replies. We'll just have to wait (im)patiently.

▶ Reply to This

Permalink Reply by C++ on January 31, 2010 at 8:32am

No need to wait, switch to an IC brand that also has a founding membership in the ODA. Companies like Bricsys are making forward progress while others seem to be withering on the vine

▶ Reply to This

▶ Reply to This