The IntelliCAD Network
progeCAD 2009 ESNAP
Well I made the switch to Windows 7 64 bit, Good OS and very snappy. ProgeCAD 2009 seam to load OK but the snaps don't work right and I can't draw a straight horizontal line with ortho on. I am running it in XP sp3 mode but still no joy. Any ideas what it might be, or do I wait and hope that progeCAD Pro 2010 solves this problem?
Thanks ahead of time.
Thanks ahead of time.
Replies to This Discussion
-
Permalink Reply by progeCAD USA on -
You should not need to run in XP mode, just the two printer drivers, the jpg and pdf printers, those need to run under xp mode until the 2010 version is released. Thats the only errors that have been reported as far as I know. As to the snap issue, try turning flyover snap off and see if they work. Also, put your bug report in on the support page at www.icadsales.com so it will make it to the manufacturer. Now, I don't believe that 2009 is going to be tested and/or updated for Windows 7 since they are fairly close releasing 2010. We have upgrade pre-orders on our website at icadsales that you can purchase for the price of the current upgrades.
Thanks
-
Permalink Reply by Daniel on -
Thank you for your reply. How does one go about singling out the jpg and pdf printers for progeCAD pro 2009 and applying XP mode.
-
Permalink Reply by progeCAD USA on
-
Please see this post on our website http://www.icadsales.com/index.pl?id=;isa=Message;op=show;mid=481;f... for a discussion of how to install those printers in xp compatibility mode.
Daniel said:Thank you for your reply. How does one go about singling out the jpg and pdf printers for progeCAD pro 2009 and applying XP mode.
About
Badge
© 2010 Created by Deelip Menezes.
Powered by 
.
